Netfloor USA ECO Cable Management Access Flooring

Flank Caps form the basis for the integrated cable trenches as well as help lock the UNIPANELS into position. Flank caps are easily removed to run additional wires and cables without affecting the integrity or alignment of the floor. Made from high strength steel with a matte black finish.

A Central Cap is placed at the intersection of cable trenches, on a 2'x2' grid. Central caps help lock the UNIPANELS into position, but also serve as a junction point for the cable trenches. Made from high strength steel with a matte black finish.

Base Connectors help lock the UNIPANELS into place and keep the floor square. A small margin of 1/16" is built into the Base Connectors to facilitate lining up and squaring the floor when the first panels are laid. Once several panels are laid down and checked for alignment, the UNIPANELS and Base Connectors lock into place and are immobile. Made from high strength plastic.

A closed cell foam sheet underlayment is the first item to be laid down. It provides a thin layer on which the entire Cable Management Floor system is installed. This underlayment helps dampen any noise from loads and movement on the floor above, as well as provides insulation between your concrete slab and the floor system.

End Caps are part of the cable trench system, and are used to finish off the end of a cable trench row when it meets a wall or partition. Made from high strength steel with a matte black finish.

A specialized flank cap, for the cable trenches, that has an opening for wire access. Almost always paired with a Grommet.A specialized flank cap, for the cable trenches, that has an opening for wire access. Almost always paired with a Grommet.

Made from ABS plastic, these simple and effective grommets are matched to the flank caps, allowing you to pull cables and wires from the cable trench at any location. Easily installed and rearranged if needed.

This fine-crafted aluminum edge trim piece is sold in 78" lengths and is used to neatly finish the edge of the cable management floor. Often used on the sides of ramps, it can be used along any edge, if desired. Included features are built in slots to secure your floor finish (carpet, tile, etc.) and a high visibility, glow in the dark safety strip to ensure occupant safety along the ramps.

Edge Rail is used to finish the edges of the Cable Management Access Floor if a full-width panel is not used, or if there is any space between the edge of the last panel and the wall. Available in several widths (80mm, 150mm, 200mm).

Ramp sections in a 4" or 24" width can be joined together to form a ramp of any width. Standard ramp slope is 1:12. Other slopes are available. *Please contact us for further information on optional slopes.*

Trimmers are used to provide a smooth, uniform finish along the entire edge of the access floor. If medium or wide base molding is to be used in the room along the edges of the floor, these trimmer pieces may not be necessary. Dark gray color to closely match the UNIPANELS.

This support brace is used at any edge of the access floor where a precise cut was made to the UNIPANEL without leaving any mini pedestals at the edge of the panel. The support is installed under the edge of the UNIPANEL to ensure a strong uniform support structure all the way to the wall. The edge support is not always necessary; please contact us with your room dimensions and layout for further information.